Output for programming track on IB-II

Depending on the DCC- digital control unit there are differnt charecteristics for the TCCS you need to consider.

Moderator: Jens Kupfer

Antworten [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1275: count(): Parameter must be an array or an object that implements Countable
Benutzeravatar
Franz Giesen
Site Admin
Beiträge: 223
Registriert: 29 Mär 2015, 15:05
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1275: count(): Parameter must be an array or an object that implements Countable

Output for programming track on IB-II

Beitrag von Franz Giesen » 16 Mai 2016, 10:46

To the users IB-II,
it is advisable on account of the kind of the current detection of an IB-II to switch a load resistance of approx. 1.2 kOhm in parallel with the outputs 1 & 2 of the IB-II (output program track). The resistor must be able to stand a load of 1 W. In the clinging figure (
IB-II PRG-Gleis Widerstand 1200.JPG
IB-II PRG-Gleis Widerstand 1200.JPG (273.08 KiB) 749 mal betrachtet
) are switched two resistors of approx. 2.4 kOhm in parallel. Otherwise it can come to reading mistakes with engines with low current !
Subsequently we must point out to the fact that the output of the program track admits a source current of max. approx. 700 mA. If a locomotive with empty storage is put on this track, it can come for over current fault of the IB-II!
Hence, the identification and also uncoupling of carriages is not possible on this track!
T4T Support

Antworten [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1275: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1275: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1275: count(): Parameter must be an array or an object that implements Countable